Code: SKU-002795
This 12-inch (30-cm) cable has 26 AWG wires with a 3-pin female JST PH-style connector that works with Sharp analogue distance sensors that have mating PH connectors. The other ends of the wire are terminated with male pins for 0.1" housing . More Details...
Code: SKU-005962
This is a 12 inch servo extension cable that comes in handy when your servo is further away from the controller than the wire on the servo allows. The male connector on one end goes to controller, while the female connector mates with servo. More Details...
Code: SKU-002410
This 24-inch (600-mm), flat cable has 22-AWG wires and female “JR”-style connectors on both ends, the same kind of connector commonly found on RC hobby servos. More Details...
Code: SKU-003086
This 24-inch (600-mm), flat cable can be used to extend the leads of many common RC hobby servos. It has 22-AWG wires, and both the male and female cable ends are compatible with both JR- and Futaba-style connectors, allowing it to work in either system or as an adaptor between systems. More Details...
Code: SKU-002409
This 6-inch (150-mm), flat cable has 22-AWG wires and female “JR”-style connectors on both ends, the same kind of connector commonly found on RC hobby servos. More Details...
Code: SKU-003078
This 18" (45 cm) harness has an inline on/off switch, with a 0.1" 3-pin female connector on one end and both a male and a female connector on the other. More Details...
Code: SKU-003085
This 12-inch (300-mm), flat Y-cable can be used to split a single RC hobby servo signal into two identical outputs. It has 22-AWG wires terminated on all three ends by “JR”-style female connectors, which are compatible with 0.1" header bins and both male JR and male Futaba J connectors. More Details...
Code: SKU-002411
This 12-inch (300-mm), flat Y-cable is typically used to connect two servos to a single servo port . It has 22-AWG wires terminated on one end by a “JR”-style female connector and on the other by two “JR”-style male connectors. More Details...
Code: SKU-003084
This 12-inch (300-mm), flat Y-cable is typically used to connect two servos to a single servo port . It has 22-AWG wires terminated on one end by a “JR”-style female connector and on the other by two Futaba J male connectors, allowing it to work in either system or as an adaptor between systems. More Details...
Code: SKU-003072
This 12-inch (300-mm), twisted cable has 22-AWG wires and female “JR”-style connectors on both ends, the same kind of connector commonly found on RC hobby servos. More Details...
Brands