Control two brushed DC motors using these motor controllers. Different sizes are available to power small to medium sized brushed DC motors. Capabilities can include full speed and direction control with feedback support and built in PID control.
Interfacing to the controllers can be done via methods such as USB, TTL Serial, Analog or Radio Control signals.
Code: MCU-60102
Get your Rover 5 moving! The Dagu Rover 5 Explorer PCB for 2wd Rover chassis is the easiest way to get started. Featuring dual FET 'H' bridge motor drivers, encoder support, 3A regulator for servos, 5 & 3.3V LDO regulators for microcontroller and sensors, built in trickle charger, IR sensors and ... More Details...
Code: MCU-60068
This tiny breakout board for TI’s DRV8833 dual motor driver can deliver 1.2 A per channel continuously (2 A peak) to a pair of DC motors. With an operating voltage range from 2.7 to 10.8 V and built-in protection against reverse-voltage, under-voltage, over-current, and over-temperature, this dri... More Details...
Code: SKU-003058
This tiny breakout board for TI’s DRV8835 dual motor driver can deliver 1.2 A per channel continuously (1.5 A peak) to a pair of DC motors, and it supports two possible control interfaces for added flexibility of use: IN/IN and PHASE/ENABLE. More Details...
Code: MCU-60023
The L298 is a high voltage, high current, dual full-bridge motor driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. More Details...
Code: MCU-60106
The L298N based motor driver board can be used to control two brushed dc motors with a continual current of up to 2A per motor. It features a large heat sink and screw terminals for easy installation. More Details...
Code: MCU-60148
This shield makes it easy to control two high-power DC motors with your Arduino or Arduino-compatible board. Its dual robust VNH5019 motor drivers operate from 5.5 to 24 V, deliver a continuous 12 A (30 A peak) per motor, or a continuous 24 A (60 A peak) to a single motor connected to both channe... More Details...
Code: MCU-60075
This dual brushed DC motor driver, based on Freescale’s MC33926 full H-bridge, has a wide operating range of 5 – 28 V and can deliver almost 3 A continuously (5 A peak) to two motors. More Details...
Code: MCU-60073
This shield makes it easy to control two brushed DC motors with your Arduino or Arduino-compatible board. Its dual MC33926 motor drivers operate from 5 to 28 V and can deliver a continuous 3 A per motor. These great drivers also offer current-sense feedback and accept ultrasonic PWM frequencies f... More Details...
Code: MCU-60004
Pololu's Qik 2s9v1 is an inexpensive and small motor controller that makes it easy to vary the speed and direction of small brushed DC motors from your microcontroller. The controller supplies 1A continous current at 4.5-13.5V with a peak of 3A. The controller itself operates at 3.3V or 5V and us... More Details...
Code: MCU-60005
This tiny board is an easy way to use Toshiba’s TB6612FNG dual motor driver, which can independently control two bidirectional DC motors. An operating range of 4.5 – 13.5 V and peak current output of 3 A per channel (1 A continuous) make this a great motor driver for low-power motors. Outputs can... More Details...
Brands
Gift Vouchers
