Antenna extend the range of transmitters and receivers by emitting or absorbing more of the radio waves. These antenna are suited to devices operating in typical 2.4Ghz unlicensed spectrum common to home WiFi.
Code: SKU-000082
Need range? 2.4GHz Large Duck Antenna 5dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance. This antenna mates nicely with the Reverse Polarized SMA Connector. Dimensions: 0.5x7.7" Documents: Datasheet More Details...
In stock in Australia
We can ship 385 more in 7-10 days
Code: CCW-20152
2.4GHz Duck Antenna with Reverse Polarized - SMA RF connector rated at 2.2dBi and 50 ohm impedance at 4" (100mm) long this antenna is a good balance of size and performance. Useful for extending the range of a WiFi device. More Details...
In stock in Australia
We can ship 215 more in 7-10 days
Code: SKU-000335
This is a 4" connector cable that interfaces U.FL RF connectors to regular SMA connectors. Documents: Datasheet RF Connector Buying Guide More Details...
In stock in Australia
We can ship 960 more in 7-10 days
Code: SKU-007615
This small form-factor antenna offers a 2.4GHz frequency range. These antennae offer adhesive backing that simplifies mounting within the device for a FPC or PCB. More Details...
In stock in Australia
We can ship 596 more in 7-10 days
Code: CCW-20151
This Interface connector cable is for joining U.FL RF connectors to RP-SMA antenna. Handy for joining those little surface mount WiFi connectors to a duck antenna. More Details...
In stock in Australia
Our supplier is out of stock
Code: SKU-000090
PCB edge mount - SMA RF connector. Perfect for prototyping with the GPS and Cellular devices that require an antenna connection. These connectors have a female signal pin and will correctly mate with the original SMA type antennae. Documents: Datasheet SMA Tutorial More Details...
In stock in Australia
We can ship 43 more in 7-10 days
Code: SKU-000356
This is an inner thread (outer nut) adaptor that will connect to any of our wireless boards or interface cables and allow you to use an antenna/cable that has an outer thread configuration. You should not need this adaptor with any of our antennae or dev boards. More Details...
In stock in Australia
We can ship 612 more in 7-10 days
Code: SKU-005918
If you need maximum distance for your LoRa project you need this incredibly durable, outdoor antenna with 5.8dBi gain. This 860-930MHz antenna is 90cm / 35.5" long and includes hardware for pole mounting. More Details...
Special Order
We can ship 1007 more in 7-10 days
Code: SKU-000024
2.4GHz ceramic chip antennae. Very small antennae that work nicely with the Nordic ICs. Don’t expect these little guys to perform as well as their ~2" rubber duck counter parts, but then again, these will squeeze onto any PCB layout. Dimensions: 2.2x6.5mm Documents: chip-antenna-2.4ghz.pdf More Details...
Special Order
We can ship 9 more in 7-10 days
Code: SKU-007786
The GW.17 Click–in Terminal Antenna is a high performance robust 2.4GHz dipole antenna designed for quick assembly onto finished products. The specially designed click in plastic head greatly reduces the assembly time and cost compared with most terminal antennae with a connector. More Details...
Special Order
We can ship 58 more in 7-10 days