The A4988 stepper motor driver carrier is a breakout board from Pololu for Allegro’s easy-to-use A4988 microstepping bipolar stepper motor driver. The driver features adjustable current limiting and five different microstep resolutions. The driver operates from a supply of 8 – 35 V and can deliver up to 2 A per coil.More details...
Designed for the Rover 5 chassis but great for any robot this controller features 4 motor driver channels rated at 4A each, easy logic control, current sensing and encoder feedback support for 4 quadrature encoders.More details...
Dagu Mr. Basic Dual 2A Motor Controller Board is designed specifically for Mr. Basic but can be used for custom robots too. Capable of working from 3.6V - 6V this PCB provides speed (PWM) and direction control of 2 motors with up to 2A per motor. Over half of the PCB is double sided project board with plate through holes for maximum versatility.More details...
Get your Rover 5 moving! The Dagu Rover 5 Explorer PCB for 2wd Rover chassis is the easiest way to get started. Featuring dual FET 'H' bridge motor drivers, encoder support, 3A regulator for servos, 5 & 3.3V LDO regulators for microcontroller and sensors, built in trickle charger, IR sensors and heaps of prototyping space.More details...
The DRV8825 stepper motor driver carrier V2 is a breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver. The DRV8825 features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (down to 1/32-step). Operates from 8.2V - 45V and delivers 1.5A per phase without a heat sink. 2.2A with cooling.More details...
This tiny breakout board for TI’s DRV8833 dual motor driver can deliver 1.2 A per channel continuously (2 A peak) to a pair of DC motors. With an operating voltage range from 2.7 to 10.8 V and built-in protection against reverse-voltage, under-voltage, over-current, and over-temperature, this driver is a great solution for powering small, low-voltage motorsMore details...
The DRV8834 stepper motor driver carrier is a breakout board for TI’s DRV8834 microstepping bipolar stepper motor driver. The DRV8834 features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (down to 1/32-step). Operates from 2.5V - 10.8V and delivers 1.5A per phase without a heat sink. 2.2A with cooling.More details...
The L298 is a high voltage, high current, dual full-bridge motor driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors.More details...
The L298N based motor driver board can be used to control two brushed dc motors with a continual current of up to 2A per motor. It features a large heat sink and screw terminals for easy installation.More details...
The L298N based motor driver board can be used to control two brushed dc motors or a 4 wire stepper motor with a continual current of up to 2A per motor. With optical isolation this board is resistant to interference and the on board voltage regulator can supply 5V ~1400mA to your microcontroller. A large heat sink cools the L298N chip and there are lots of LEDs so you know what's happening.More details...
